Home > Switch Questions

Switch Questions

May 12th, 2015 in SWITCH 300-115 Go to comments

Question 1

Explanation

The command “mac address-table aging-time 180” specifies the time before an entry ages out and is discarded from the MAC address table. The default is 300 seconds. Entering the value 0 disables the MAC aging.

Question 2

Question 3

Explanation

The switch learns which port the host is attaching by examining the source MAC address in frames received on a port. For example switch receives a frame with source MAC of 0000.0000.aaaa (abbreviated as “aaaa”) on port Fa0/1, it populates its MAC address-table with an entry like this “host aaaa on Fa0/1”. If the switch receives a frame with the same “aaaa” MAC from Fa0/2 then there will be a flap and the switch will log something like this:

%MAC_MOVE-SP-4-NOTIF: Host 0000.0000.aaaa in vlan 1 is flapping between port 0/1 and port 0/2

This flapping phenomenon may be the result of a Layer loop somewhere in your network, especially when STP is disabled for some reasons.

If you don’t want to see this message then issue the “no mac-address-table notification mac-move” or place a static entry with the “mac-address-table static 000.0000.aaaa vlan 1 interface fa0/1″on the switch. The command “mac-address-table notification mac-move” is disabled by default on 6500 & 7600 series but enabled by default on other series.

Question 4

Explanation

Storm control prevents traffic on a LAN from being disrupted by a broadcast, multicast, or unicast storm on one of the physical interfaces. A LAN storm occurs when packets flood the LAN, creating excessive traffic and degrading network performance. Errors in the protocol-stack implementation, mistakes in network configurations, or users issuing a denial-of-service attack can cause a storm.
Storm control (or traffic suppression) monitors packets passing from an interface to the switching bus and determines if the packet is unicast, multicast, or broadcast. The switch counts the number of packets of a specified type received within the 1-second time interval and compares the measurement with a predefined suppression-level threshold.

Storm control uses one of these methods to measure traffic activity:
+ Bandwidth as a percentage of the total available bandwidth of the port that can be used by the broadcast, multicast, or unicast traffic
+ Traffic rate in packets per second at which broadcast, multicast, or unicast packets are received
+ Traffic rate in bits per second at which broadcast, multicast, or unicast packets are received

With each method, the port blocks traffic when the rising threshold is reached. The port remains blocked until the traffic rate drops below the falling threshold (if one is specified) and then resumes normal forwarding. If the falling suppression level is not specified, the switch blocks all traffic until the traffic rate drops below the rising suppression level. In general, the higher the level, the less effective the protection against broadcast storms.

The command “storm-control broadcast level 75 65” limits the broadcast traffic up to 75% of the bandwidth (75% is called the rising threshold). The port will start forwarding broadcast traffic again when it drops below 65% of the bandwidth (65% is called the falling threshold).

Note: If you don’t configure the falling threshold, it will use the same value of the rising threshold.

Reference: http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_25_fx/configuration/guide/2960scg/swtrafc.html#wp1063295

Question 5

Explanation

By using the “storm-control broadcast level [falling-threshold]” we can limit the broadcast traffic on the switch.

Question 6

Explanation

The command “show mac address-table” displays the MAC address table along with the port associated for the switch. The ‘show mac address-table address ” gives a more specific view of a specific MAC address.

Question 7

Question 8

Explanation

The command “storm-control action {shutdown | trap} ” specifies the action to be taken when a storm is detected. The default is to filter out the traffic and not to send traps.
+ Select the shutdown keyword to error-disable the port during a storm.
+ Select the trap keyword to generate an SNMP trap when a storm is detected.

Comments
Comment pages
  1. Anonymous
    March 17th, 2016

    where are the current dumps?

  2. dbangfele
    March 17th, 2016

    please can someone send me the latest ccnp dumps to davakaniruatgmaildotcom. thanks!

  3. Jane
    March 22nd, 2016

    could somebody send me the dumps 191q please. It will be a big help. I do request. Thanks in advance. my email address

    jane_woken52 @ yahoo.com

  4. FustratedCCNPLoser
    March 26th, 2016

    My exam was taken on 3/25/2016 as I ended up with a humiliating 643/1000. All my study material was from the CiscoPress eBook (300-115), CBT Nuggets, VCE dumps (191q) and Certprep. I put in 6-7 study hours a day for nearly a month to pass 300-115 with extreme confidence, but I was shot down when I was roasted by the exam. The latest dumps from this site only covered about 25% of the questions given, but all the Lab Sim simulation were correct as I had LACP with STP / HRSP / AAA. I was easily able to finish the lab sims on the exam with success but fell way short when it came the questions with educated guesses. I would like to know if anyone can help me out to receive the latest dumps soon. Thanks. c_brotha @ yahoo.com

  5. coolpass
    March 28th, 2016

    @ all
    I took the exam and I passed with a score of 937 out of 1000.
    Study dumps from EnsurePass.Here is the question from it.

    The network monitoring application alerts a network engineer of a client PC that is acting as a rogue DHCP server. Which two commands help trace this PC when the MAC address is known? (Choose two.)
    A. switch# show mac address-table
    B. switch# show port-security
    C. switch# show ip verify source
    D. switch# show ip arp inspection
    E. switch# show mac address-table address
    Correct Answer: AE
    Explanation:
    These two commands will show the MAC address table, including the switch port that the particular host is using. Here is an example output:
    Switch>show mac-address-table

    Dynamic Addresses Count: 9
    Secure Addresses (User-defined) Count: 0
    Static Addresses (User-defined) Count: 0
    System Self Addresses Count: 41
    Total MAC addresses: 50
    Non-static Address Table:
    Destination Address Address Type VLAN Destination Port
    ——————- ———— —- ——————–
    0010.0de0.e289 Dynamic 1 FastEthernet0/1
    0010.7b00.1540 Dynamic 2 FastEthernet0/5
    0010.7b00.1545 Dynamic 2 FastEthernet0/5

    However, I highly suggest to read the Cisco Press and watch CBT nuggets tutorials.
    Thanks for sharing your experienced here and thanks Certprepare.

  6. CBTNugget
    March 31st, 2016

    Someone has weblink or torrent with CBT nuggets tutorials ?

    Tk u mate

  7. ihsan
    March 31st, 2016

    HI can you share your dumps ?

  8. CCNP candidate
    April 3rd, 2016

    kindly pass me ccnp latest dumps to shakeelanwar at eim dot ae

  9. Confused
    April 6th, 2016

    Where can I find the 191q dump? I got the premium membership so is it just all the questions on the site?

  10. anu
    April 11th, 2016

    Can anyone please send me latest updated dump ?
    email id : {email not allowed}

  11. anu
    April 11th, 2016

    Can anyone please send me latest updated dump ?
    anushka.bhnd @ gmail dot com

  12. Switch
    April 13th, 2016

    Please email me any dump that are available
    DOC0516 @ aol dot com

  13. Black dog
    April 19th, 2016

    Can anyone please send me the latest dump ?
    kaduceus369 @ gmail dot com

  14. Anonymous
    May 4th, 2016

    new to the site,, what is the 191q dumps?

  15. Kangas
    May 11th, 2016

    hi guys,

    Just finished with CBT, switch Book and self study now i want to go over these labs. Could anybody send me latest Dump please {email not allowed}.

    Thanks in advance

  16. Kangas
    May 11th, 2016

    sousalucas @ htm dot com

  17. Punana
    May 12th, 2016

    Can someone send the latest dump for 300-115 on {email not allowed} .

  18. Alinora
    May 13th, 2016

    Hi guys, here pass4sureexams providing valid pdf dumps of http://pass4sureexams.com/300-101-exam-questions.html

  19. Greg
    May 14th, 2016
  20. Anonymous
    May 23rd, 2016

    passed today got 890. be careful in etherchannel lab.

  21. walker
    May 25th, 2016

    want to get high marks in final IT Exam.. Get pdf dumps from here http://www.pass4suredumps.com/300-320.html

  22. D
    May 26th, 2016

    Could someone please send a link or the file of the latest 300-115 dumps to dinn.nnid at gmaiI dot com

  23. Anonymous
    June 13th, 2016

    Where can the dumps be found?
    Is it worth to purchase premium?

  24. ahmed erlrofaie
    June 25th, 2016

    can any one send me the last dump for 300-115 i will so thankful my email is ahmedrofaii at gmaiI dot com

  25. Gihan
    July 9th, 2016

    Hi,

    Recently, I personally passed CCNP Route 300-101,SWITCH 300-115,TSHOOT 300-135 exams with full marks.
    I have purchased latest Premium vce dumps file that are 100% valid and I’m giving at nominal sharing cost.wanninayakegcb@gmail_com

  26. Anonymous
    July 11th, 2016

    Hi Can someone please share the latest CCNP Switch 300-115 dump

  27. marco
    July 16th, 2016

    Why I cant loggin???

  28. 6alloul
    July 18th, 2016

    can anyone send me the CCNP exam Questions on my email talboun91(@gmail.com)

  29. Anonymous
    July 18th, 2016

    why I am not able to see questions on any page :(. Help me out

  30. Need latest Dumps
    July 23rd, 2016

    Hi guys ,please help me. I need latest CCNP Dumps for Routing and Switching Exam.
    Thanks in Advance. {email not allowed}

  31. Need latest Dumps
    July 23rd, 2016

    regtoaamir(@yahoo.com)

  32. naija
    August 1st, 2016

    pls ccnp route self sturdy book to sharkz _ ibt @ yaho o . c om

    pleaseeeee

  33. Anonymous
    August 2nd, 2016

    wanninayakegcb@gmail_com
    what is your email address this one does not work

  34. skymax
    August 6th, 2016

    wanninayakegcb (at) gmail (dot) com

  35. Anonymous
    August 21st, 2016

    can someone send latest dumps me too kapydan (at) yandex (dot) ru

  36. Masiku
    August 25th, 2016

    Good day Cisco people
    Please can someone send me the Latest Switch exam on nathan@intelligentsoftware(dot)co(dot)za

  37. Hossam Shaaban
    September 3rd, 2016

    I need to download Exam Labs (300-115) please any one can help me

  38. Notmyrealname
    September 6th, 2016

    I failed switch by 10 marks! aargh..
    Is there anyone who has failed the first time and passed it again?
    Can we expect some questions from the 1st or will it be completely new questions?
    Especially for simulations?

  39. Anonymous
    September 7th, 2016

    Hi all,

    please can someone send me the latest dumps to {email not allowed}? cannot find them in Examcollection

    thanks in advanced!

  40. Anonymous
    September 8th, 2016

    please send latest dumps : dhw19sav{@}gmail.com

  41. GDAY
    September 9th, 2016

    @Notmyrealname what did you use to study. I plan on taking it in two days…

  42. Anonymous
    September 9th, 2016

    please send latest dumps :{email not allowed}

  43. Anonymous
    September 9th, 2016

    please send latest dumps :abbas19501{@}gmail.com

  44. burned
    September 9th, 2016

    I spent alot of time studying other than list of questions from this site . That was a somewhat waste of time as Surprisingly all the questions were the same as I downloaded from a link in comments at certprepare. I should have studied just certprepare with fulll questions and answers. I was lucky the link was there and remembered the cerprepare q and a.
    But didnt know labs AAA and STP Lacp inside and out. Drag and drop was cdp and lldp features. and hsrp sim Find the link or pay and get questions as they are same as tst

  45. effbee0
    September 14th, 2016

    Please send me latest dumps. effbee0 (at) gmail (dot) com

  46. nandy
    September 16th, 2016

    hi,

    please send me switch and route troublest dumps on my mail {email not allowed}

  47. nandy
    September 16th, 2016

    hi please
    send me ccnp
    hello(dot)email2015(at)gmail(dot)com

  48. onyimx
    September 16th, 2016

    pls can someone help me with d switch latest dump. my exam is in 3 weeks time. {email not allowed}

  49. onyimx
    September 16th, 2016

    pls can someone help me with d switch latest dump. my exam is in 3 weeks time. onyifreeman{@}yahoo{.}co{.}uk

  50. UK
    September 18th, 2016

    Passed my CCNP switching (979 points) on 17th of September.
    All question were from 191q (still valid).
    Labs: AAA dot1x and LACP
    Sim: HSRP
    Drag and drop: CDP and LLDP

    Good luck to everyone!!!

Comment pages
  1. No trackbacks yet.